OO Gauge – Fuelling Grids – FOR PECO’S NEW CODE 75 BULLHEAD TRACK ONLY

Single Centre Grid and Extension Outer Grid.

Why not add some more detail to your diesel depot layout and in the form of these fuelling grid packs.
Available at DCC Train Automation as a Pack to include a single centre section and an outer extension grids to make up approx 170mm worth of fuelling grid. You can add additional packs to make up the length that is required.
The centre section piece has 1760 grid holes in it, so these do take time to laser cut and therefore reflected in the cost of production.

Made from our ModelBord, these can be easily made up in a short period of time. The centre section piece has been designed so that it simply slots inbetween the sleepers on the flexible track and can be glued in place (recommended). Due to the new Bullhead track being a lot more flexible/flimsy, you may be required to trim the parts between the sleepers off for our grids to fit neatly. The outer extension pieces simply butt up against the side of the rail just above the chair and gives as close as finish to the rail as possible but also being slightly under the rail height. Again, these can be glued in place once done.
If you have ballast the track already where these grids will go then you may find that you will need to remove the ballast to allow fitting of these.

Please note – track is NOT included in this kit!