Product features and functions

For optional operation with digital systems according to SelecTRIX 1 and 2 or NMRA standard (DCC)

In digital mode, the last programmed system is used (it will not switch automatically!)

SelecTRIX 1 31 speed steps, 100 addresses

SelecTRIX 2 127 speed steps, 10,000 addresses, 16 additional functions

DCC short addresses (1-127), long addresses (0001-9999), with 14, 28, 126 speed steps

Load control of the latest generation, therefore particularly soft control behavior

Various control variants for optimum adaptation to the engine

Internally 127 speed steps

Adjustable motor frequency (16 kHz, 32 kHz)

Block section operation with simple diodes in digital mode

Light outputs dimmable

Shunting

Motor, light and track connections electronically exchangeable

All function outputs freely programmable

temperature protection

Reset function for DCC and SX2

Update capability of the decoder

The update (the firmware download from the Internet is free of charge) is possible on the track when the decoder is installed (no need to open the vehicle) and can be done either via the FCC digital control unit or the programmer . If no corresponding hardware is available, the company provides Doehler & Haass to request a programmer on loan.

The Nano Lokdecoder PD05AŒæ supports braking with asymmetrical digital voltage (four diodes in series and a diode antiparallel), the slow speed (with suitable brake modules) and bidirectional communication (Lokadressrí_ckmeldung in DCC operation, RailComŒ¬).

The Nano Lokdecoder PD05A does not support analogue operation. The Nanoξ Lokdecoder PD05Aξ does not support SX1 programming. Set up SX1 operation with SX2 parameter programming.